Thread
:
Project Texa Go
View Single Post
09-13-2013, 11:15 PM
#
73
Billett
Registered User
Join Date: Jun 2012
Location: Pittsgrove, NJ
Posts: 1,502
Re: Project Texa Go
Well here's the start of it all!
Brought home the 6.0l on March 17 and started tearing into it that weekend.
Pulled the heads to make sure everything looked good inside. Cleaned the engine up a bit, but only painted the valve covers and front and rear covers.
One of the things I had to take care of was my column. I switched from a 4 speed w/ granny low to a 4l80 and my CFO wanted some more leg room so I had to go to an auto column. I figured while i was at it I would do an OE tilt column! Didn't realize I would need to get an intermediate shaft also...
PO had everything sealed up with this foam garbage...
New gauges
There she is all painted up with the headers on, waiting to get dropped in
__________________
Will
1968 C10 -
Project Texa Go
6.0/4L80e
2003 Mitsubishi Lancer Evolution
2002 Ford Excursion 7.3L
2024 Toyota Sienna
Billett
View Public Profile
Find More Posts by Billett