The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Xeen · 10-10-2013, 08:21 PM

Hey all;
Today I started on the fan relay harness.
I need some 10-12ga. non-insulated butt connectors to finish the job so I need to track them down locally tomorrow.

Here is my progress so far, I repaired the weatherpack connectors with 3x14ga. wires and 1x 12ga. wire for common ground, 4x 14-16ga. non-insulated butt connectors, then I soldered and shrink wraped them.
This picture also shows my relays.

Here is the diagram I am using for the fan relay harness.
This setup has 3 states, Off, both fans Low speed and both fans High speed, which is controlled by the PCM.

10-10-2013, 08:21 PM	#575
Xeen Registered User Join Date: Aug 2012 Location: Topeka Kansas Posts: 2,655	Re: 1968 Chevrolet SWB Stepside Restomod Hey all; Today I started on the fan relay harness. I need some 10-12ga. non-insulated butt connectors to finish the job so I need to track them down locally tomorrow. Here is my progress so far, I repaired the weatherpack connectors with 3x14ga. wires and 1x 12ga. wire for common ground, 4x 14-16ga. non-insulated butt connectors, then I soldered and shrink wraped them. This picture also shows my relays. Here is the diagram I am using for the fan relay harness. This setup has 3 states, Off, both fans Low speed and both fans High speed, which is controlled by the PCM. __________________ Please call me Brian. Check out My 1972 SWB Fleetside 5.3L Vortec Restomod Build Last edited by Xeen; 10-10-2013 at 08:38 PM.