The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Johnnyfever · 10-17-2013, 10:06 AM

I used a titanium drill bit to drill a hole in the head of the bolt and used an easy-out in the newly created hole in the bolt head. Then just a ratcheting wrench on the nut underneath. And I had to do this on every single bolt I had. Only took about 45 minutes after I picked up the titanium 3/16" bit....cut through like butter.

10-17-2013, 10:06 AM	#7
Johnnyfever Registered User Join Date: Oct 2011 Location: Belton, SC & Atlanta, GA Posts: 181	Re: When blowing apart your beds, I used a titanium drill bit to drill a hole in the head of the bolt and used an easy-out in the newly created hole in the bolt head. Then just a ratcheting wrench on the nut underneath. And I had to do this on every single bolt I had. Only took about 45 minutes after I picked up the titanium 3/16" bit....cut through like butter. __________________ Yes, it's a Short Wheel Base, not a Short Wide Bed.