The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Mondo · 10-20-2013, 02:35 PM

The guy at the Chevy dealership said something about not getting a brake signal. The only modern pedal I installed was the throttle. Do I need to install some kind of brake switch?
I don't have any emissions on the truck either (just the O2 sensors after the headers). so can we get around the "ready" checklist?
Appreciate the help BR

PS- had to go back to the new computer as the original started acting up... high idle still continued and started dropping a cylinder (funny, the transmission would shift normally when the cylinder cut out). Anyway, I'm sure it's do to those pins that were bent. So I really need to solve this relearn issue.

10-20-2013, 02:35 PM	#8
Mondo Registered User Join Date: Aug 2007 Location: Bakersfield, Ca Posts: 538	Re: dilema The guy at the Chevy dealership said something about not getting a brake signal. The only modern pedal I installed was the throttle. Do I need to install some kind of brake switch? I don't have any emissions on the truck either (just the O2 sensors after the headers). so can we get around the "ready" checklist? Appreciate the help BR PS- had to go back to the new computer as the original started acting up... high idle still continued and started dropping a cylinder (funny, the transmission would shift normally when the cylinder cut out). Anyway, I'm sure it's do to those pins that were bent. So I really need to solve this relearn issue. Last edited by Mondo; 10-20-2013 at 02:41 PM.