The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

nvrdone · 10-27-2013, 10:54 PM

Taking the seat frame out is easy. After removing the seat cushions, there are two nuts on the back cross piece that are a bit of a pain but not bad. There is room to work with out removing the tank.There are also two nuts on the front corners of the seat frame. It helps to have another person to take the frame out. Take it out the passenger side.
I mounted my lap belts to the back and side frames, not thru the floor. I did use some 1/4" plate for reinforcement. They actually held good when I rear ended a car a few years ago.

10-27-2013, 10:54 PM	#3
nvrdone Registered User Join Date: Dec 2011 Location: Moxee WA Posts: 1,498	Re: Installing seatbelts Taking the seat frame out is easy. After removing the seat cushions, there are two nuts on the back cross piece that are a bit of a pain but not bad. There is room to work with out removing the tank.There are also two nuts on the front corners of the seat frame. It helps to have another person to take the frame out. Take it out the passenger side. I mounted my lap belts to the back and side frames, not thru the floor. I did use some 1/4" plate for reinforcement. They actually held good when I rear ended a car a few years ago.