View Single Post
Old 10-30-2013, 09:06 AM   #6
Keith Seymore
Registered User
 
Keith Seymore's Avatar
 
Join Date: May 2009
Location: Motor City
Posts: 9,285
Re: AT Radiator Question

Quote:
Originally Posted by ksshane View Post
I noticed it, but wasnt 100% sure what it was. Believe me.. there is no telling what the PO did to this truck. He had a 4X6 half inch piece of plywood screwed to the side of the radiator support for some reason and the screws where 3 to 4 inches long themselves, so there was few inches of screw sticking out the back side of the radiator support.
He used old shirts to fill in rusted out holes in the fenders and then painted over them with primer. Wires are hanging everywhere not connected to anything... just wrapped around things to keep them from hanging down. There are a few wrapped around my heater hoses, and one around my power steering assy.

So seeing a couple of hoses cut by bolt cutters didnt really set off any red flags...lol
In your defense....sounds like there was a lot going on with this one....

(lol)
__________________
Chevrolet Flint Assembly
1979-1986
GM Full Size Truck Engineering
1986 - 2019
Intro from an Old Assembly Guy: http://67-72chevytrucks.com/vboard/s...d.php?t=342926
My Pontiac story: http://forums.maxperformanceinc.com/...d.php?t=560524
Chevelle intro: http://www.superchevy.com/features/s...hevy-chevelle/
Keith Seymore is offline   Reply With Quote