The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

litew8 · 11-05-2013, 04:32 PM

A couple hours worth of work update.

The only snag we've run into so far. The front panel wouldn't lift up far enough to line up.
We concluded this to be a stamping error and adjusted as needed. It'll clean up later.
Also, spot welds on the top insides of the bedsides were hammered flat to help achieve proper clearance (upward from within).

Pass. side didn't need modified, other than hammering on the weld.

The new co-worker. He doesn't do much of anything

Heck yeah

11-05-2013, 04:32 PM	#980
litew8 Registered User Join Date: Jul 2011 Location: Des Moines, Iowa Posts: 3,016	Re: Project "My Happy Mess" A couple hours worth of work update. The only snag we've run into so far. The front panel wouldn't lift up far enough to line up. We concluded this to be a stamping error and adjusted as needed. It'll clean up later. Also, spot welds on the top insides of the bedsides were hammered flat to help achieve proper clearance (upward from within). Pass. side didn't need modified, other than hammering on the weld. The new co-worker. He doesn't do much of anything Heck yeah __________________ project: "my happy mess"