Quote:
|
Originally Posted by aotte1
I checked my bumper part number, it is "14043837 S". Will have to check the last "3" in daylight to make sure it is not an "8". tongue weight is 400 lbs and load is 4,000 lbs.
|
Well, that part number seems to match up with the correct bumper for a stepside so that's a good sign.
Quote:
|
Originally Posted by aotte1
Ray,
Will provide some basic measurement of mine to see if we can determine the difference between step side and fleet side bumpers. Thanks for the diagram.
|
You're welcome. After looking at a fleetside bumper and comparing it to the one in your pic, I am going to retract my earlier statement about yours looking like a fleetside bumper. Although I thought it looked a bit wide, I don't think that is the determining factor.
The difference I noticed is at the outer corners. The forward facing edge of your bumper appears to be straight across. A fleetside bumper on the other hand has small notches at each corner that allow for clearance where the lower/rear corners of the bedsides protrude back beyond the rear cross sill.