[dec010974]

well hart rod, I used two cut up engine harnesses to make one harness. the pins and connectors that were missing, I bought, connected them, and made it work. I used the harness information from LT1swap.com. he also programmed my pcm. word of advice, get the harness and pcm from the same vendor or source. when I wired my harness, I checked every pcm pin to its right connector. I also removed all the stuff/wires lt1swap said to remove. its not that hard. you gotta have a system. my notes are very detailed and I emailed Brendan when ever I had question. trust me, I killed two harness b4 I got this one right. u have my number. call me if you get lost. if need be, send me a harness, and ill wire it for you. ill use the info from lt1swap. just pay for your supplies and shipping. be warned, i have not checked the odb2 connector for codes. I have been driving around the neighbor hood. since I have an aftermarket cam, head port work, springs, stall converter, it will need a final tune from am reputable tuner. but at least I can get the groceries. clark.