The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Front end coversion and something went wrong

FoMoCoGuy · 11-18-2013, 04:04 PM

Hey guys, I did a power steering, power disc conversion on a 64 c10 a while back. When it was taken to get aligned, the camber is WAAY out. Lots of positive camber. with all the spacers taken out it still has too much.

Here are the parts we used

- stock upper control arm
-88-98 3/4 ton spindle
-81 lower control arm
- stock wheels

Where did i go wrong?

11-18-2013, 04:04 PM	#1
FoMoCoGuy Registered User Join Date: Feb 2013 Location: Portland, Or Posts: 13	Front end coversion and something went wrong Hey guys, I did a power steering, power disc conversion on a 64 c10 a while back. When it was taken to get aligned, the camber is WAAY out. Lots of positive camber. with all the spacers taken out it still has too much. Here are the parts we used - stock upper control arm -88-98 3/4 ton spindle -81 lower control arm - stock wheels Where did i go wrong? Last edited by FoMoCoGuy; 11-18-2013 at 04:11 PM.