The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Phlebmaster's 1964 GMC 3/4 ton Evolution- full of pics and win!

Phlebmaster · 11-30-2013, 08:08 PM

More updates..... We disassembled the 350 TBI to get it ready for the rebuild. :-)

This looks good! I don't know what those numbers mean, but the transmission looks very clean.

I had to pull the engine out of the bed and onto the stand by myself....that was tricky!! But I did it..

I'll have to look up those numbers on the TC....

Pulled the TC and put on the stand mount.

This was the tricky part.... I used a come along and a jack and went back and forth slowly until the engine stand wheels were safely on the ground. :-)

Finally!!

Now I can get started.... Waited for my daughter to start.

There she is....Teenagers, geeze!

That TBI was a rats nest!!

This engine is set up for rollers!! Pre- machined and tapped....I am interested even more now in using this block.

Finally tucked away into the shed where I will spend the winter months rebuilding it.

Thanks for everyone's help so far!

I am not so sure about the TBI set=-up, the electronics intimidate me a bit but I know there is a ton of documentation and resources for the TBI so I won't whimp out just yet and go to the carb. lol

11-30-2013, 08:08 PM	#10
Phlebmaster Registered User Join Date: Nov 2009 Location: Oregon City, OR Posts: 146	Re: Phlebmaster's 1964 GMC 3/4 ton Evolution- full of pics and win! More updates..... We disassembled the 350 TBI to get it ready for the rebuild. :-) This looks good! I don't know what those numbers mean, but the transmission looks very clean. I had to pull the engine out of the bed and onto the stand by myself....that was tricky!! But I did it.. I'll have to look up those numbers on the TC.... Pulled the TC and put on the stand mount. This was the tricky part.... I used a come along and a jack and went back and forth slowly until the engine stand wheels were safely on the ground. :-) Finally!! Now I can get started.... Waited for my daughter to start. There she is....Teenagers, geeze! That TBI was a rats nest!! This engine is set up for rollers!! Pre- machined and tapped....I am interested even more now in using this block. Finally tucked away into the shed where I will spend the winter months rebuilding it. Thanks for everyone's help so far! I am not so sure about the TBI set=-up, the electronics intimidate me a bit but I know there is a ton of documentation and resources for the TBI so I won't whimp out just yet and go to the carb. lol __________________ Thanks, Aaron Life is about making dreams come true, stop dreaming and make life happen. 64 GMC Project MY_YOUTUBE_VIDEOS To keep an opened mind- speculation is devine. Assumptions always lead to a dead end!