I made a huge mistake sigh..I open my door to back up normally when I try to measure how far my rear bumper is or in a tight spot REASON being my stupid mirrors are not adjusted and I can't see sh$&.Anyway today I nearly tore the damn door off by getting it hooked on a pole right near me.My driver door was wide open when it nearly got folded on its back but not quit.The door is preety much bent from stress in the middle and has more importantly has the edges of the fender bent preety good looks like a damn car hit it (folded in).The door sags down about 1 large inch! And doesn't hit the striker I can't close the door.I think it can't close because number because possible mounts or pints OBVIOUSLY but also the fender edge where the door meets fender is so badly folded in and its scuffing and clenching the door.
How much is this going to cost
This is a 82 silverado with done paint job not expensive just normal metallic grey.Rest of truck is fine just door and fender fold