[spartakus]

Good luck.

The bars need to be .75" longer to work w/ even thread spacing(s) on the adjusters. They were going to send me "special length" longer bars but, sent bars that were way too long. I ended up just moving the front brackets back about .75", so as to leave the axle centered correctly (which btw works out w/ the rear fender placement and their "rear frame to axle tube measurements". Moving the brackets back is a pain due to the increasing taper in the frame.

Between the front and rear kit - I had several issues beyond this also. Bottom line is (at least for me), this was a case of "you gotta figure out a lot of this on your own" vs not exactly plug and play.

Let me know if I can help w/ anything else.