The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

67chevy1 · 12-11-2013, 09:17 PM

I think I would probably either clean the ends of the axle tubes up and duct tape around the ends of the housings or take it all the way apart where there are no parts in it. Get it cleaned down to where there is no oily or sticky residue for media to stick to. Then blast it and after words clean very thoroughly again. Not sure that I would do any of it though I think I would take a die-grinder with a scouring head on and go to town.

12-11-2013, 09:17 PM	#2
67chevy1 Registered User Join Date: Nov 2013 Location: marshall, il Posts: 282	Re: medai blasting 12 bolt axle housing ??? I think I would probably either clean the ends of the axle tubes up and duct tape around the ends of the housings or take it all the way apart where there are no parts in it. Get it cleaned down to where there is no oily or sticky residue for media to stick to. Then blast it and after words clean very thoroughly again. Not sure that I would do any of it though I think I would take a die-grinder with a scouring head on and go to town.