|
Re: one piece driveshaft
"A known lenght" sure if there wasn't a half dozen locations the engine and trans could be mounted using only stock parts.
Measure YOUR truck at ride height with the engine and transmission installed. Call a DRIVELINE shop and have them build you a shaft to your specs and have them BALLANCE the shaft after it has been ASSEMBLED. You can order premade shafts from parts houses but then you have to ad the trans yoke and ujoints, that's like ballancing your wheels before you install the tires.
__________________
67, swb, fleet, tach, throttle, 5.3, 4l60e, 3.73's, fuel cell, 5 lug, p.d.b., 4-6 drop. great little truck
66, stevens drag/ski 18' silouette, 350, 2.02 doublehump heads. comp extreme marine 278 cam, vette 7 fin valve covers, old polished edelbrock intake, velvetdrive, casale v-drive, adj cavitation plate.
28, model a rpu project,
|