The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

63 & 64 Bowties · 12-22-2013, 08:49 AM

You could probably put masking tape on the front side, mix up some two part epoxy, apply to back side, remove the tape which kept the epoxy from oozing through to the front, re-install. I'm not familiar with the 59's trim, is this held on with pal-nuts? If so, just don't over-tighten or it will break again.

12-22-2013, 08:49 AM	#7
63 & 64 Bowties and a few others Join Date: Jun 2007 Location: Blue Ridge Mountains of VA Posts: 5,638	Re: '59 Gmc Hood emblem You could probably put masking tape on the front side, mix up some two part epoxy, apply to back side, remove the tape which kept the epoxy from oozing through to the front, re-install. I'm not familiar with the 59's trim, is this held on with pal-nuts? If so, just don't over-tighten or it will break again. __________________ Bill US Army Vet -193rd Infantry BlueRidgeMuscleCars.com “The greatness of a nation and its moral progress can be judged by the way its animals are treated” Gandhi