[arrover]

I felt like I needed to check out the front axle bearings, seals, brakes, etc since I'm not sure when they were done last. The Dana 60 isn't terribly complex. I've never been inside one but it's going well. I decided to replace the inner bearings/races, seals, and spindle bearings/seals. I thought that the wheel bearings always came with races but that isn't the case I found out. I probably would be done by now but I'm waiting on the races... The spindle bearings are hard to get out of the spindles. A straight punch doesn't really work. I used a small pry bar that got bent a full 90 degrees before the bearings finally came out.