The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

TDS-MN · 01-08-2014, 08:13 AM

does your truck have a/c? I have heard that it's a bigger job if so, but I did this on my non-a/c '85, and it wasn't that bad. Most of the work was from the engine bay. I used a Haynes manual as my guide, and I had mine apart and back together in a couple hours.

In my case, the door seems to move maybe 40-45 degrees from stop to stop, so not real far, but I would say it is more than the 1/2" you mentioned.

01-08-2014, 08:13 AM	#3
TDS-MN Registered User Join Date: Sep 2009 Location: Mpls, MN USA Posts: 151	Re: Heater Blend Door does your truck have a/c? I have heard that it's a bigger job if so, but I did this on my non-a/c '85, and it wasn't that bad. Most of the work was from the engine bay. I used a Haynes manual as my guide, and I had mine apart and back together in a couple hours. In my case, the door seems to move maybe 40-45 degrees from stop to stop, so not real far, but I would say it is more than the 1/2" you mentioned. __________________ TomS. '98 S-10 Blazer 4dr 4wd - 4.3, AT, stock & '85 K-10 w/ 305, 700r4, np208, and RUST! SOLD Dec 2014