Working on a 66 C-20 longbed since August 2013. Replaced all the rusted panels in the floor. Removed front and rear suspensions blasted and powdercoated the frame rails. I purchased an 87 silverado rust bucket with 90K miles and drove it for 2 months it runs and shifts great. Presently dismantling the 87. I plan to install complete front crossmember and power steering into the 66. Anyone have alignment specs for something like this? Was going to rebuild the motor/trans but for now will just clean paint and install into 66. I plan to remove all the air pump and egr and rest of the smog stuff and use the 87 wiring harness for the tbi motor. Future plans include installing the 87 rear end (3.42 Ratio) and leaf springs as well andl install a set of duramax aluminum wheels on the 8 lug suspension.