|
Well I thought some 69s had open knuckles? At any rate it would be easier to get a dana 44 or 10 bolt from a 73 or newer GM vehicle and install it. Just get the correct brake lines for the axle (banjo fittings changed). Also 73 and newer had larger u-joint, but 71-72 will work the same.
I believe another member kept his stock 4 drum master cyclinder w/ disc up front and had enough to work the calipers.
__________________
1970 K25, 8' stepside bed 350/465/205 44 up front, 60 in the rear 4.10s rolling on 33" Dunlop MTs
1986 K5, 350/465/208 Dana 60/14 bolt from a cucv 36" Super Swampers TSL/SX
1983 K20 w/ CUCV axles, 350/700R4/208 sitting on 37" Goodyears
1986 M1031 6.2 diesel, TH400/NP205 locker in the rear and a LS in the front, all stock for now.....
1986 K30, 350/400/205 dana 60 and 14 bolt. I kept the drivetrain. Body/bad and chassis are gone.
1981 K30, 350/465/205 dana 60 and dually 14 bolt. Has a G80, and a flat bed. Going to replace the flat bed.
1985 K20, 350/400/208 10 bolt and SF 14 bolt. I wonder where I can find some 1 tons. Hmmmmm 
|