[99 to Life]

1-19 I didn't get to work on my truck last weekend because I worked on my daily driver, very annoying. So I tore into the cab some more, tore out the Ebrake, may or may not use that set up, but I had to get it outta the way so I can tear into the floor. You can see the drivers side mess I gotta deal with.

I started on the pass side. didn't get a bead roller yet, so I just did up a kick panel with 18g. I had some inner cowl pieces I got from another project and I have some outter cowl pieces from another parts buy, a guy made them, not me. but they should work and save me some money. I can't put them in until I patch the tail end of the rocker, its just a bit too flimsy for my liking. I gotta make another patch on the bottom of my kickpanel so I can tie it into my tubing on the floor. I fell short on some calculations.

did up a few more pieces of floor tubing. I'm at over 30ft of it already, still need to do more. Up in the pass corner I'm going to make my cab brace where you see the small boxed in area, I'm gonna weld some plate in there and use that, rather than put the original cab brace in right there. Might do that on the driver side too.