The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - PROBLEM with Driver Window not wanting to roll up

**WIDESIDE72** · 01-24-2014, 02:48 PM

If a roller breaks the flat spot it creates wedges its self into the track.

As far as window installation, it used to give me fits too til i figured it out.

1. Remove bolts at bottom of rear glass guide.
2. Loosely install regulator in door with 2 bolts
3. Crank window regulator all the way up til rollers stick up through opening.
4. Slide glass channel onto rollers from outside truck
5. Crank window down and install remainder of all attachment bolts loosely.
6. Roll window up and down to ensure it doesnt bind
7. Tighten bolts

Note: I have never done this with the horizontal window felts/ rubbers installed. I pit them in last.

01-24-2014, 02:48 PM	#5
WIDESIDE72 Senior Member Join Date: Aug 2008 Location: Cedar Park, Texas Posts: 7,500	Re: PROBLEM with Driver Window not wanting to roll up If a roller breaks the flat spot it creates wedges its self into the track. As far as window installation, it used to give me fits too til i figured it out. 1. Remove bolts at bottom of rear glass guide. 2. Loosely install regulator in door with 2 bolts 3. Crank window regulator all the way up til rollers stick up through opening. 4. Slide glass channel onto rollers from outside truck 5. Crank window down and install remainder of all attachment bolts loosely. 6. Roll window up and down to ensure it doesnt bind 7. Tighten bolts Note: I have never done this with the horizontal window felts/ rubbers installed. I pit them in last.