|
Re: replacing a quadrajet with a used holley 600
Quote:
Originally Posted by dhughins
Here is a before pic.
|
after looking at the pics again , i would defiantly find a good used intake and pull those valve covers as well and clean and paint those up as well make the top end brighten up a bit
i have owned a few edlebrock carbs in my day and i always had a stumble or hesitation in them and yes i tried changing springs and metering rods ect ect as the techs suggested always switched over to a Holley in the end
__________________
Mike
72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider.
421 SBC / TH350 3000RPM Stall
Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks 
|