[jd21476]

Ok, so humor me on this. I know my drawing is bad but I used MS paint. So my idea is to take a large metal funnel and weld on a bent piece of pipe out of the bottom. Then, weld on a gas cap that has a hole cut in the middle that is the same size as the pipe. Add a piece of fuel line to fit into the filler neck. When you get to the gas station you remove your old fuel cap and just screw on the new fuel cap with the funnel sticking out. If you weld on the fuel cap at the right angle it should make the funnel stand straight up when locked in. You can then fill up by holding the CA emissions thingy back with one hand and the pump in the other. No more mess.