The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

PortHeadlight · 02-07-2014, 10:39 PM

I don't know whether or not it's the same seat...but I measured the bottom of the top section of the original console and it's 19". If you look at the picture showing the side, it looks like the base of the original console is a bit longer than the seat and it tapers back... maybe even a full inch if you consider the back is also at an angle. I'm guessing they are very similar in length at it could work. The front of the curved bottom base that I made is right up to the edge of the piping.

The width of the console is about 11.25" Hope this helps.

02-07-2014, 10:39 PM	#10
PortHeadlight Registered User Join Date: Nov 2007 Location: Cape Elizabeth, Maine Posts: 196	Re: Bench seat console I don't know whether or not it's the same seat...but I measured the bottom of the top section of the original console and it's 19". If you look at the picture showing the side, it looks like the base of the original console is a bit longer than the seat and it tapers back... maybe even a full inch if you consider the back is also at an angle. I'm guessing they are very similar in length at it could work. The front of the curved bottom base that I made is right up to the edge of the piping. The width of the console is about 11.25" Hope this helps.