[Vintage Windmills]

Revisiting the list

New things to do:
-Fix washer pump and replace wipers
-Troubleshoot parking lights always on, even with key off!
-Rebuild turn signal and horn switches on column

Must haves to hit the road:
Done- hook up tail and side lights
Done- hook up replacement voltage regulator
Done- figure out why no headlights
Done- install dimmer switch
Done- straighten cab back enough to install rear window
Done- install shocks
Done- patch floor temporarily
- install seat
Done- install gas tank
- replace pass door handle
- install drivers mirror
- change oil
- install front bumper
Done- drill frame for 2nd set of rear bumper bolts (this one was off a C20, which have closer
Done- install new fuel pump and line
- balance tires

Nice to haves:
Done- rebuild heating system (core is plugged big time and fan doesn't run)
Done- route wires for interior cab light
- install grille
- reseal/regasket tcase
- replace bent tcase member
- install Gearvendors I have
- rebuild double cardan joint
- install 285’s
- replace battery tray
- weld trim holes and paint tailgate and install

Long Term Wishes:
- Replace driver door, and both front fenders
- Patch rust in floor
- patch rust above visors or replace roof
- replace inner fenders
- install rear slider
- install floor insulation
- paint front clip and cab to match box.
- Drop the Cummins in there?
- Swap the Dana 61 in front?[/QUOTE]