Quote:
Originally Posted by greystoke
where would you recommend hooking up the chain to. I have the clip off. The truck resides in gravel/dirt so I'm using an overhead 1ton hoist.
|
I pulled the 292 with the 4 speed from my '67 C20 and I ran a chain around the intake or exhaust manifold about 8 or 10 inches from the back of the engine. I just looked for a clear hole the chain would go through. The other end of the chain picked up a bolt hole on the bell housing on the opposite side of the motor.
If you have removed the floor shift lever it should come straight out. The U-joint probably has a 4 bolt yoke so that has to come apart too.