Quote:
Originally Posted by WIDESIDE72
Did you adjust the column by using the drill bit thru the hole method? Are your bushings good?
|
Actually the first part of the adjustment that I did not relate to the linkage alignment. All it does is tighten or loosen the levers. There is a collar with three bolts that you loosen and turn the collar to tighten or loosen. The adjustment I did worked flawlessly for a few hours. It was like it had all new stuff. It shifted smoothly. Later I checked the linkage adjustment by going to neutral position, used a 3/16 in bit to check that alignment you mentioned. And it lined up perfectly with no need to adjust. Linkage themselves are fine.