[enonz65c30]

Originally Posted by BMERDOC

Do you plan on blasting the new cab? Nice welder! That thing should do the trick.

Thanks Nick, I cant wait to try out the welder.

I did not get much done yesterday. I was able to clean the shop up a bit and get the cab on a cart so I can roll it around with out the use of the tractor. I was going to build a cart that used the factory body mount locations and raise it up off the ground higher, But after looking at my front floor supports I realized that they needed to be replaced as well. so I decided to keep it low and make the cart so I can hinge the cab on its nose to make it eayser to get to the bottom of the cab. I plan on extending the cart a little so it will be stable I figure I can crib up the firewall when its on its nose so all the weight is not on the two front brackets. I have a long way to go before this cab is ready to hit the frame, but I think its worth the effort on the big window considering I was looking at doing the same amount of work to the smaller window cab.




Im glad I already have about 75% of the patch panels I need from topbanna