The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Anyone sell a non-solid, lower-a-arm shaft??

Injected68LS1 · 12-29-2003, 12:46 AM

I should do some stress calculations on the spindles and the shafts. I bet you could do over 6g on the skid pad. I bet you could also apply 10 tons to the lower control arm(pulling outward toward the side of the truck).

12-29-2003, 12:46 AM	#5
Injected68LS1 Registered User Join Date: Jul 2003 Location: So. Cal. Posts: 389	I should do some stress calculations on the spindles and the shafts. I bet you could do over 6g on the skid pad. I bet you could also apply 10 tons to the lower control arm(pulling outward toward the side of the truck). __________________ 1968 Chev SWB with 1998 Corvette LS1 305hp and 320 ftlb to the wheels (stock engine!) AEM EMS and wideband O2 sensors Bowtie Overdrive's 700R4, stage 3 Baer 4 wheel discs and 20s http://iciclelanding.com/aperture?album=2049&view=album