The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

NEWFISHER · 03-13-2014, 01:22 AM

Capt fab is correct on the linkage build. Guy took coat hanger and ran the path. Used 1/4 rod and bent the angles in a vise with round pipe on one side and a couple 2x stock ends on the other. Threaded the trans end and screwed on a hiem joint. Ran the upper rod end through the selector arm, tightened it down after securing the hiem to the trans arm. I just spent 30 min trying to find the pics but all I could see in the threads at the bottom is capt fab and me reading the same ones lol.

03-13-2014, 01:22 AM	#4
NEWFISHER Registered User Join Date: Sep 2012 Location: Oregon Posts: 3,303	Re: Engine Swap: I6/3 Spd to 350/350 Capt fab is correct on the linkage build. Guy took coat hanger and ran the path. Used 1/4 rod and bent the angles in a vise with round pipe on one side and a couple 2x stock ends on the other. Threaded the trans end and screwed on a hiem joint. Ran the upper rod end through the selector arm, tightened it down after securing the hiem to the trans arm. I just spent 30 min trying to find the pics but all I could see in the threads at the bottom is capt fab and me reading the same ones lol. __________________ GOD BLESS AMERICA! Last edited by NEWFISHER; 03-13-2014 at 02:08 AM.