Re: 64 Chev C10 Slam (Noob Style)
Hi there, Lowl!f3 , Thank you, Im still in the process of getting the bags to sit just right, and trimming up the LCAs so it all works without rubbing. Almost done though , and ill have my buddy weld in extra plates on the LCAs to reinforce what I cut out,
The intake is just the normal one for single carbs you see all over ebay, I took it to the Welding shop and had the temp plugs welded solid.
Carbs, 2 to one adapters, air filters, Intake heater, headers, and linkage all come from Tom Langdon.
The bags rubbed on the stock LCAs I cupped, Now that they are off a truck Ill just take time and alter them a bit more on the bench, and use them on my next truck, Im startin a fleet :O)
I cupped them with 1/4 plate steel, I made the patterns and took them to a local fab shop and had them cut out, I welded them together, it was cheep and would have worked fine if Id made the cups as big as possible the first time.
After I raise my trans Ill figure my ride height, then pinion angle if I been readiing right,
Have a good week.
Last edited by 64chevtruck; 03-17-2014 at 02:25 AM.
|