The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Porterbuilt mild steering shaft pic request

rwade · 03-26-2014, 07:24 PM

Hey guys, I'm almost at the point of installing my steering shaft set up and Dave said it would be recommended to get an aftermarket steering column to make installation easier. I'd rather not spend another $400 & I'd like to use my factory tilt column. Have any of you installed the mild or touring drop member and used your factory column (tilt or non tilt)? Pictures and and measurements of the two shaft set up would be GREATLY appreciated!

Thanks, Wade

03-26-2014, 07:24 PM	#1
rwade Registered User Join Date: Apr 2010 Location: Louisiana Posts: 970	Porterbuilt mild steering shaft pic request Hey guys, I'm almost at the point of installing my steering shaft set up and Dave said it would be recommended to get an aftermarket steering column to make installation easier. I'd rather not spend another $400 & I'd like to use my factory tilt column. Have any of you installed the mild or touring drop member and used your factory column (tilt or non tilt)? Pictures and and measurements of the two shaft set up would be GREATLY appreciated! Thanks, Wade