Quote:
Originally Posted by gmachinz
That junction will work for power to your relay. As for the proximity of the switch wire to the exhaust, that Calterm type plastic connector won't like the heat and will distort over time. The wiring I doubt is j1128 spec so it isn't designed for resisting underhood heat....especially so close to the exhaust. Will the setup work? Sure but for how long is the question. If that switch is a 180 degree switch mounted in the head, once the fan comes on, it'll likely never go off until you turn the engine off. Typically, cylinder head coolant passages are about 15-25 degrees hotter than an intake coolant passage-I would suggest running a 225-230 degree switch in the head or, relocate the one you have to the intake.
Keep in mind that a cheap relay used for allowing a fan to run for long periods of time can overheat the contacts within the relay coils and not let it release when it should-that's why Flexalite controllers are imo JUNK. They overheat too often and remain running when they shouldn't. This is why I suggest swapping out your relay for a HD diode and resistors equipped one. Not only are the contact materials able to resist overheating much better, but the diode prevents any spiking when the fan shuts off. Combined with a resistor, its a gradual shut down of the relay-which is a good thing.
|
Unfortunately I have no choice but to put the temp switch in the cylinder head. Someone put a plug in the second coolant passage in the intake and must have glued it in with some loctite because I have tried everything to get it out. I have tried a long handled ratchet with a cheater bar and also my impact. It is an allen head plug so it's going to end up stripping out if I try too hard.
Any recommendations on a good relay that I can just buy over the counter?
I really don't want to go scour junkyards for a relay if I don't have to.