Re: 60-66 Stepside rear step bumper modification
Hey WhippinSaw, you are making great progress! Side pieces are looking really good! I must admit however that I am not sure why the vertical section of diamond plate is sagging? I did notice that in your last pic on post #33 you can see that there is a downward dip in the vertical piece of diamond plate & a downward dip in the horizontal piece towards the vertical. That distortion may be due to the rust build up at the outer edge? So perhaps when you removed the extra flat section of diamond plate the vertical piece took on more of the slope downward due to the missing horizontal section. Hopefully once you add in the new section of horizontal (step section) of 1/8" diamond plate under the vertical piece, the vertical section can be pushed up with a floor jack and tack welded to see if the sag is corrected. Not sure if that makes any sense? Kind of hard to describe. This was my first time working with diamond plate too so I'm afraid I'm no expert! If the sag is not corrected when the new horizontal piece is installed you may need to cut some of the vertical section further towards the center of the bumper and splice in a new piece. Not sure if this is of any help but I hope the sag can be corrected. Keep us posted!
Murph.
|