The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

colgad · 05-01-2014, 08:33 AM

1. Glass is easy, heat the frame with propane torch by moving the flame QUICKLY across the frame. Pry the old glass out gently using screw driver or ( I used paint sticks that I cut down). LMC has the rubber gasket for the seal (cheap) push seal into frame (a little soap) push glass into frame, the gasket will move and you will have to do it a couple of times but it is not that hard.
2. No clue, My C50 does not have any carrier
3. Neither one of my C50's had them due to on was a box and one a flatbed
4. I would say change it to a newer 100 amp

05-01-2014, 08:33 AM	#2
colgad Registered User Join Date: Jun 2006 Location: Lutz, Florida Posts: 838	Re: Few random questions 1. Glass is easy, heat the frame with propane torch by moving the flame QUICKLY across the frame. Pry the old glass out gently using screw driver or ( I used paint sticks that I cut down). LMC has the rubber gasket for the seal (cheap) push seal into frame (a little soap) push glass into frame, the gasket will move and you will have to do it a couple of times but it is not that hard. 2. No clue, My C50 does not have any carrier 3. Neither one of my C50's had them due to on was a box and one a flatbed 4. I would say change it to a newer 100 amp __________________ 1967 Red, C10 Short Bed 6.0L T5 5 speed 1967 Orange and Black C50 6.2 Detroit Diesel NV4500, 2 Ton Pickup 1972 White, Chevy Blazer 2WD 67 Dog house 5.3 4L65 2016 Power Tour LH 1955 Red-Cream, Chevrolet Nomad, restoration on hold 2004 Black, Corvette Z06 LS6 convertible (Rock solid Fun) 2011/2018 Power Tour