The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Noob with a torch, cutting off spring perch technique

earl84 · 05-02-2014, 11:27 AM

OK, thanks for the advice. I am probably going to attempt this in the next few days after practicing on something else.

Followup question, I only have a 110 MIG welder. I don't think that is gonna be enough to weld on perches, so had always planned on taking it somewhere to get it done. Does that sound about right to everyone?

05-02-2014, 11:27 AM	#6
earl84 Registered User Join Date: Aug 2011 Location: Montrose, CO Posts: 972	Re: Noob with a torch, cutting off spring perch technique OK, thanks for the advice. I am probably going to attempt this in the next few days after practicing on something else. Followup question, I only have a 110 MIG welder. I don't think that is gonna be enough to weld on perches, so had always planned on taking it somewhere to get it done. Does that sound about right to everyone?