Re: Updating here
ok, so I was able to remove the rear drag link from the pitman arm.. I went to Carquest and rented a Spindle Nut removal tool, for FREE! All you have to do is put a deposit down and when you return it they refund your money.. pretty cool, oh and I can use for up to 30 days..
So I removed everything on the axle except for the ball joint knuckles. I was kind of over removing ball joints at that point. It did make it a little more challenging for sanding but I think I was able to hand sand in and around those tight areas..
When I was at Carquest, I picked up about 7 different size steel wheel wires for an electric drill. It worked pretty good, but next time i will haul the axle somewhere and pay someone to sandblast it.. I think I spent a total of 16 hours prepping this axle.. It had a ton of grease, rust, corrosion.
Here's a pic before the first coat of primer and one with the first coat of primer. I'm going to put one more silver primer coat and then finish with a top coat of chassis black gloss.. I used MasterCoat .
|