[sdwolff98]

Well to throw outta a few updates. My first fuel injection harnes sI built for this ole big block was too short in all the wrong areas so it has become the sacrificial lamb for a vortec 454 harness I just picked up for a franklin. Plans are to strip the covering off the 454 harness then go through and pull the pins out of the 454 computer connectors and restab em in the corresponding LS1 computer connectors lol time consuming but the length in the harness assemblies is way noticeable. Also wednesday having my son roll over to fed ex freight center and pick up my 1993 chevy truck nv4500 that is coming in from kentucky lol long story there. got it and the friehgt for 639$. If luck still holds I may be landing a ranger overdrive unit in a couple of weeks Also I have a check coming in late this week early next week will provide my truck rescue transport funds for first week of august. I will be flying down to fix the rear bearings in the axles and get him rolling enough to load on an enclosed trailer and bring him home already got the garage spaced cleared and ready plus plenty of space for all the parts boxes in the abck of the truck /sigh so dammed ready!!!!!

Sean

On a side note have picked up a couple of drive by wire chevy lq4/lq9 drive by wire harnesses I am working on stand alone converting as something to keep me from going stir crazy lol