The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Russell Ashley · 06-25-2014, 05:13 PM

I got my Scott's bolt in cross member installed finally. All 32 bolts are in and tight and the engine is sitting on the new side mounts. If my calculations are right my wheels will be a half inch forward from their original location. I only moved them that far as I though they looked about right before. I am planning on starting an install thread but want to get farther along first.

My pic from Photobucket didn't make it. I'll try again.

06-25-2014, 05:13 PM	#3543
Russell Ashley Registered User Join Date: May 2010 Location: Lawrenceville, Ga Posts: 2,648	Re: What Did You Do With Your Truck Today ? I got my Scott's bolt in cross member installed finally. All 32 bolts are in and tight and the engine is sitting on the new side mounts. If my calculations are right my wheels will be a half inch forward from their original location. I only moved them that far as I though they looked about right before. I am planning on starting an install thread but want to get farther along first. My pic from Photobucket didn't make it. I'll try again. Last edited by Russell Ashley; 06-25-2014 at 05:32 PM.