[mud.man.rj]

Just about anyone makes a good lift, Superlift, Rancho, lots of main brands. Could buy add a leaf kit for the front, which could be installed w existing u bolts if they come apart easily and an adda leaf kit or blocks for the rear, most add a leaves add about 2.5 to 3" so cheaper or could buy a dedicated lift of complete spring packs for front and rear..or also a cheaper kit would be a kit with a front spring pack and rear block to add under your leaf pack which can easily be a 4" lift. Any more than 4" mean drive shaft mods which cost to much so stick w 4" or less. W a 4" total spring lift should squeeze a 35" tire, tight but will work so a 33" will easily fit. Like I mentioned earlier the width is a huge factor because it comes into play when turning and rubs, so a skinnier 35" that is 10.50 wide will fit a 4" easily but a wider 12.50 width will maybe rub or be close. Check out some lift sites. Must have some shops in your area you could talk to. Buy a kit w shocks so the length is correct for the lift.