I also cleaned and installed the starter. This drivetrain was missing the dust shield on the bell housing so I have to go to pull a part and get one and a few other little parts.
Now with the Hedders on I started the exhaust. I am using a Flowmaster S bend assortment box and Summit racing H pipe balance tube kit.
Hedders fit pretty good
The first pipe getting mocked up. Exhaust work is not much fun when its 100* outside. I was dripping in sweat!!
Driver side pipe mocked up
Getting it all tucked up over the trans X member. I think I am going to split the trans X member so I can actually get the tranny out for service in the future..
