The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

pohnjarker · 08-29-2014, 12:01 AM

looking around online and reading, i think the gears are 3.08 but wont know for sure until i pull it and open it up but you're right, i will put some 3.73s in there when i do.

i'm not entirely set on any parts because of the budget and the million different combinations out there. but i do see what you mean about the CR with those heads. i'll keep looking around

i get what you mean about which way to start on a project. i've always started with the engine and then worked my way down but i do have other friends that like to do it your ways. to each their own though, nothing wrong with either way IMO, just preference.

enjoy Okinawa bud, my brother was there for a little while and liked it pretty well before he went to training on Mt. Fuji.

08-29-2014, 12:01 AM	#11
pohnjarker Registered User Join Date: Aug 2014 Location: DFW, Texas Posts: 23	Re: New C10 stock engine build with a twist looking around online and reading, i think the gears are 3.08 but wont know for sure until i pull it and open it up but you're right, i will put some 3.73s in there when i do. i'm not entirely set on any parts because of the budget and the million different combinations out there. but i do see what you mean about the CR with those heads. i'll keep looking around i get what you mean about which way to start on a project. i've always started with the engine and then worked my way down but i do have other friends that like to do it your ways. to each their own though, nothing wrong with either way IMO, just preference. enjoy Okinawa bud, my brother was there for a little while and liked it pretty well before he went to training on Mt. Fuji.