Got quite a bit done this weekend.
Out with the old harness.
In with the new harness.
SSSsssshhhhh, She has quiet moments every once in a while...
This will be a very non-typical dashboard setup. Cut out a thin piece of sheet steel to mount inside of the plastic cluster for my switches/lights/gps to mount to.
Took my tonneau cover/toolbox/gas tank out and mounted an over the rail toolbox from my old Dodge. I am going to get a slightly smaller gas tank with fuel pump and mount it back up under the truck.
I need to pick up a bunch of little LED's for turn signals, switches, and some other stuff. This wire harness should help a lot with the new engine install as it is pre-wired for fuel pump, sending unit, etc.