Quote:
Originally Posted by keh27
This is correct, after checking with a buddy and looking his truck the rear end is off to the right side he has the two piece drive shaft. The one piece drive shaft tents to make it look worse. the engine wasn't centered in the pic so it is better than the pic, I will look into again once the body is back on. I will post more pics at that tome. The X measurements are around 1/8 inch of each other . So I will let everyone know how it turns out. Thanks everyone. for all the help
|
Sounds like the "X" measurements are really good.
Curious about the drop member and your pinion angle vs your output shaft angle. Is it parallel coming straight out the trans and straight out the pinion, on the same plane?