View Single Post
Old 10-17-2014, 02:29 PM   #6
bowtieguy79
Ephesians 2:8
 
bowtieguy79's Avatar
 
Join Date: Mar 2008
Location: Delavan, IL
Posts: 677
Re: Engine swap to 6.0 question...

You will need a flex plate spacer ( it most likely would already be on the 6.0 ) other than that, its going to wire exactly the same as yours. Just the PCM would need flashed for it to run properly. There are many places you can send your PCM to or I'm sure you can find a dyno shop that would custom tune it for you to.

Just be sure you look at all possible angles, I think there can be more power gained by tweaking what is there vs swapping engines alone.
bowtieguy79 is offline   Reply With Quote