The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Mr Banshee** · 11-01-2014, 06:57 PM

Yes when I began mocking up I purchased a new set of core support bushings. I have an orginal cross member from another parts truck since the one I had was butched beyond belief for the headers they used. I will try a factory member this week. I wanted to use this DIY4X member since it does have a better mount system over the factory pads. Did you use a better engine mount with a molded saftey bar in the mount or just a standard replacement rubber pad mount? Thx Mike

11-01-2014, 06:57 PM	#10
Mr Banshee Senior Member Join Date: Jan 2013 Location: Lebanon, Tennessee Posts: 223	Re: DIY4X Crossmember with a BBC Yes when I began mocking up I purchased a new set of core support bushings. I have an orginal cross member from another parts truck since the one I had was butched beyond belief for the headers they used. I will try a factory member this week. I wanted to use this DIY4X member since it does have a better mount system over the factory pads. Did you use a better engine mount with a molded saftey bar in the mount or just a standard replacement rubber pad mount? Thx Mike