[61K10]

Mitch--I had the hole third member out of the housing as it was leaking,also to ck axle bearings (which were good as was the axles). the R&P had about .250 slop (loose) i readjusted the back lash to spec. so it was worn by being out of spec, and it's not the org one either. I thank the date was 1959. might just rebuild it with 3.38's till i come up with a good 3.90. the closes r&p for the ft dana44 3.31's which is stretching it a bit. probable never use 4wd anyway. going to fix all my leeks in the t/f case and figure out the R-end. I've built a few rear ends some years ago when i was Drag racing.