[bh86]

haven't updated much lately. Things have been busy but i've been able to make some good progress and should be able to drop the cab on this week and finish up all the little wiring stuff and get it started up. Got the motor pulled from the back of the shop and put it on the stand, stripped it down, cleaned it, put in new gaskets and replaced a few sensors. I had to replace the knock sensors since one was brittle and the top piece broke off when i pulled the wiring connector off it also was brittle and cracked so i ended up making a trip to the parts store and 150$ bucks later i had both sensors and the wiring harness...ouch. I swapped out the 2 wire temp sender for a three, and made a trip to the hardware and fitting place close by and put an adaptor together for the oil pressure sender also. Swapped the cts-v pan on while i was at it and painted things up a little.