The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

elimontfort · 11-30-2014, 08:56 PM

I didn't have that problem but my motor was 1/2 inch off on the drivers side to the passenger side. I had to break all the mounts loose after I hung the transmission and pull the motor over and tighten it all back down. Also there swap cross member for the transmission wouldn't fit. I had to use my 700r4 cross member from bowtie over drives. Not really impressed with cpp right now.

11-30-2014, 08:56 PM	#4
elimontfort Registered User Join Date: Jun 2011 Location: Sunbury, N.C Posts: 140	Re: cpp stands/mounts/sliders I didn't have that problem but my motor was 1/2 inch off on the drivers side to the passenger side. I had to break all the mounts loose after I hung the transmission and pull the motor over and tighten it all back down. Also there swap cross member for the transmission wouldn't fit. I had to use my 700r4 cross member from bowtie over drives. Not really impressed with cpp right now.